While many people like to install radiators themselves, we always recommend professional installation. In the event you would like to install the radiator yourself, please read our guide on how to remove a radiator.

When installing a new radiator, be sure to examine your radiator and compare it to your original. Some replacements can differ by the core thickness or what materials that are used to make the radiator, such as plastic tanks/aluminum core, all aluminum, or copper/brass. When changing your radiator thickness, be sure that it will not interrupt any movement of your current radiator fan. Also, be sure to fully inspect the radiator for any damage prior to installation.

1. Remove any fan assemblies or sensors on the old radiator and install on the new radiator. Clean the electrical connector and make sure it is free from debris.
2. Replace any damaged hoses or clamps.
3. Start to thread transmission or engine oil cooler lines into the cooler fittings by hand to avoid stripping the threads. We recommend to leave the mounting bolts loose until all the hoses and lines are connected. Avoid over-torquing the drain plug; only hand tighten. Do not use any tools to tighten the plug as it may damage the drain plugs. With the engine idling, recheck the automatic transmission fluid level.
4. Once the installation radiator is complete and the hoses are tight, fill the radiator with a 50/50 mix of appropriate coolant and distilled water. Be sure to check your owners manual for the correct type of coolant your vehicle calls for.  If the top radiator hose sits higher (at any point) than the radiator cap, there may be a vent that you need to locate at the highest point in the system. Open the vent while filling and close the vent once radiator is full and before you start your vehicle.
5. With the cap off, start the car. The coolant will bubble and bubble out any air and foam. Some recommend to revving the motor to 2000 to get any excess air out.
6. Replace the pressure cap. Start the engine and check for leaks.
7. After the engine has idled long enough to open the thermostat (engine should reach its normal operating temperature), turn the engine off. Make sure the cooling system has cooled down before slowly removing the pressure cap to check the coolant level.

To view some of the radiators we have in stock, please visit our store - Aeon Imports