The following are instructions for installing a replacement battery in the Navman PIN Pocket and were provided by one of our customers. Thank you for your contribution!

=========================================

Here are the steps you may pass these steps to other customers when you sell Navman Pin battery to them

- Remove SD card and place the Navman on a soft surface face down so that you do not scratch the LCD screen.

- Take out 4 screws ONLY from each corner on the back.  Make sure you use a small Philips screwdriver.

- Use your finger nail very carefully around the edges, go extremely slow to detach the cover.  Once it opens, make sure of the Power switch button, they seem to fall off.

- Remove clear tapes at the battery connector.  DO NOT pull up the connector, you need to pull sideways and make sure do not use excessive pressure while pulling.

- Place the new battery in same manner and also place battery cables neatly so that the do not come in the way while closing the cover.  The LCD display should turn on.  If it does not, look at the Battery connector and make sure it is all the way in.

- Put the cover back slowly and then make sure nothing is dangling along the edges.  Do not forget to check the Power Switch button; it should be in proper place.  Press the cover firmly, it should snap in place.

- Charge the battery fully before using Navman.

- Insert SD card. You may need to reload Navman application software or restore from SD card, if you stored on the SD card previously.