As always, professional installation is recommended; however, we have provided a general set of guidelines to aid with the installation.

Suggested tools for this installation:

A. Heat Gun
B. Prying device preferably plastic.
C. Adhesive remover.(We used 3M Bug, Tar and Adhesive Remover spray)

Basic Guidelines for Emblem Install:

1. Using a heat gun on low heat carefully apply heat to the emblem. WARNING: Do not overheat parts otherwise damages may occur!
2. Attempt to remove the emblem by hand very carefully. Pay special attention not to damage the bumper surface.
3. If needed use a plastic prying device to aid with dislodging of emblem (Dental floss or fishing line has proven to be effective). WARNING! Be careful not to damage paint or bumper cover.
4. Once emblem is removed, use adhesive remover to clean surface (3M adhesive remover can be used as a cleaning agent). Surface must be clean for proper adhesion!
5. With emblem off, peel plastic mask off of new emblem.
6. Carefully apply the emblem to surface noting the alignment marks. Apply pressure to emblem on surface for duration of 60 seconds. This is important in promoting strong surface adhesion.
7. Make sure emblem is aligned and installation is complete.
8. Curing time for the adhesive is 24 hours. Do not let water or any other liquid get on the emblem or else the adhesive bond will be damaged.