This guide will help you to properly install the Lenmar Battery PMPARAV100 installation guide for Archos AV120 / AV140. You will need a Philips head screwdriver, damage may result if you attempt to use other tools than stated. Proper steps to ensure the safety of the user and device should be carefully observed before proceeding with the installation.

Lenmar Battery PMPARA120 installation guide for Archos AV120 / AV140

Step 1: Using a Philips screwdriver, remove the two screws from the battery cover located at the top of the PDA.

Step 2: With the screws removed, pull and hold the battery cover downward.

Step 3: While still holding downward, pull the battery cover away from the PDA and remove it from the device.

Step 4: Remove the battery by tipping the top portion of the device towards the floor. A slight shaking of the device should be enough to allow the battery to slip out. If the battery does not come out the entire way, pull it out with your fingers. Install the new battery by sliding it into the compartment. Please pay attention to have the original battery orientation (label up, minus towards top of PDA). Replace the battery compartment cover and put back the two screws. A minimum of three hours of charging will be needed before first use.

BatteriesInAFlash.Com, eBay Store: The Lenmar Archos® 100% OEM Replacement Battery.

Written By BatteriesInAFlash.com, Inc. eBay Store

WARNING: This battery may require special installation skills or tools to replace. For skilled end users only. BatteriesInAFlash.com, Inc. assumes no responsibility for improper assembly or excessive force that may result in damage to your Archos device by trying to install the battery by yourself.  Installing this battery requires a moderate level of technical ability and proficiency in the use of hand tools as well as a general understanding of electronic components. The user assumes full responsibility for damages or problems caused by use of these instructions.