Here is what you need.....
A: 24” or 33” inch Digiwave dish

B: 2 DSS DN circular Lnbf -LNBF. 1- ku-linear Standard LNBF Using the Digiwave LNBF will work the easiest.

C: 1-Digiwave Super Mount I or Digiwave Magic Mount III

D: Measuring device. I used a tape measure. A ruler that can measure out 1/2 inch. (Digiwave mount already mark the ruler on the holder)

Here is what you do......

Mounted the ku-linear Lnbf to the dish arm and mounted a 1/2" emt conduit pipe 6" long. I located and locked onto sat 121 with the highest quality possible and mounted the circular DN Lnbf for 119 to the right of 121 (looking at it from behind the dish) and then mounted the circular DN 110 Lnbf to the right of 119.

The brackets that hold the Lnbf are from 1/2" to 2" emt pipe clamps/brackets. With this kind of setup (Digiwave Mount) you can get 4 axes point’s adjustments: forwards/backwards, up/down, left/right, side to side. The quality for 110 will get from 90% to 100% , For 119 will get 80% to 98% and for 121 will get 70% to 95% depending on the transponder, But you would need to play with 119 to get the best quality you can for the both 119 and 121. With this kind of setup should get 82, 91, and 97 on one dish too.