Here is what you need.....
A: 1-18”, 24” or 33” inch Digiwave dish

B: 3-LNBs. Using the Digiwave LNBF will work the easiest.

C: 1-Digiwave Super Mount I or Digiwave Magic Mount III

D: Measuring device. I used a tape measure. A ruler that can measure out 1/2 inch.

Here is what you do......

Connect all 3 Lnbf to Digiwave Super Mount. Now move it so it is about 1/2 inch higher than the first. Move it so it is about 1/2 inch higher than the second. The 1/2 inch does not have to be exact, but fairly close. Digiwave Mount has Ruler mark. Hopefully, between reading and looking at the pictures, you'll make it work. First time setup took quite some time to get it figured out.

The LNB on your right will be looking at Sat. 101, the middle one 110, and the left one
Will be 119. Mount the LNBF back to a dish. Mount the middle one to dish just like normal. As for tuning, hooked up Directv to the 101 LNB and tuned it till had signal. You could also hook up DISH to the 119 LNB and tune it in. Once you have one of them working, the other two LNBF WILL be seeing signal at its respective Sat. You will probably have to compromise on signal strength depending on where you are and what you are watching.

This is working for Dishnetwork 110, 119, 121 too. But, between 119 and 121 will more close and almost on the same level.

This is working for BEV 82, 91, 97 too.

We can add more Digiwave Super mount finger in order we can add more LNB to dish and receive more satellite in one dish. For example, we can put Dishnet 110,119,121, Bev 91 together. Or combine with FTA LNB and receiver DSS satellite and FTA satellite together.