Crimp beads may be tiny but they play a big role in properly finishing a beading project.  We'll show you how to use them in this guide...

Crimps are a soft metal bead, used in place of knots to secure clasps and beads onto un-knottable thread such as Tigertail and Softflex (nylon coated wire cable).

To use crimps, you will need some flat nosed pliers to squash the crimps, or regular crimping pliers that ‘fold’ the bead into a small volume.  ( For crimps less than 2mm in diameter we recommend using a micro crimping pliers )

First, thread crimp onto wire. Loop the wire around your clasp or jump ring (the thing you want to put on the very end of the wire). Pass the end of the wire back through the crimp, so that the loop of wire is closed. Now is the time to pull the loop as tight as you want it to be, because after you finish crimping, the loop will be permanently fixed.

Next, either use specialty crimping pliers and follow the instructions that come with them, or use the flatnosed pliers as follows: Line up the crimp in the tip of your pliers as straight as possible. Hold your pliers at a right angle to your wire. Carefully squeeze down on your pliers and squash crimp flat. Your loop should be secure and permanent. If the crimp is not straight before crimping, you will get an uneven result that may not grip the wire, may be subject to breakage, and may permanently bend the beading wire.

 At Beadaholique we have a large selection of crimp beads

Find out why we have the Highest Feedback Rating of any bead store on eBay! Best prices, friendliest people.

Visit us at our beadaholique ebay storefront