Each Decal consists of 3 parts:

Please read this section carefully, especially if you are new to Rub On Vinyl Decal Installations.

Application Tape

Application Tape is the Mask that we apply to your Decal that makes multiple letters stay together. It is necessary for us to apply this Mask to make Decals ready for install. This Mask is the Clear Adhesive applied over the Decal.

Decal

This is the actual adhesive Decal that you have purchased. It is sandwiched between the Application Tape and the Wax Backing. The Decal is what ends up installed to the surface.

Backing

The backing is the heavy Wax Paper that is applied to the “Sticky” side of the decal. This backing keeps the Decal from sticking to anything prior to install.

Surface Compatibility:

The Surface must be a Hard, Flat and Non- Porous. Installation to any other surfaces is not recommended, unless you are an experienced Vinyl Installer. Special skills are needed to deal with major body lines, complex curves, corrugated surfaces, etc. We strongly suggest you wait at least 60 days after painting a surface before applying any decal, because should you ever wish to remove the decal the paint will come off with it if the paint is not properly cured before application.

Surface Temperature and Weather Conditions:

Adequate Surface Temperature and Weather Conditions are necessary before attempting to install a Decal.

- The Surface Temperature must be between 60°F and 90°F, with 70°F to 80°F being the ideal range.

- It can’t be Raining or even Drizzling. Decals must be kept absolutely dry until installed.

- Try to avoid installing Decals in Direct Sunlight. Surface Temperatures in Direct Sunlight often change rapidly and are difficult to judge.

- Make sure there is No Wind present, Wind or Gusts Will cause a problem.

Simple Method of Applying Decals

Decide where you want your Decal to go. Tape it into position with small pieces of masking tape along the top of the decal. Remove the Decal, leaving the marks on the Install Surface. Remove and discard the masking tape and backing at this time, Keeping the Decal taut and adhere Decal. With the Application Tape still intact, take your drivers license or a credit card and apply the lettering or graphic by pressing on the surface of the Application Tape. Using even strokes, start at the middle of the decal, and work your way out. Carefully remove Application Tape.