I agree with another reviewer about the Frigidaire applicances.  We swapped out our tried and true GE appliances, Refrigerator, Range and Dishwasher for Stainless Look Frigidaire appliances 1-1/2 years ago.  The Fridge has been serviced twice and thing in the cold section just don't get cold and the dial is set to max.  The ice maker always overflows and drops ice into the freezer compartments and the doors are not even and one side opens when you close another.  We are getting rid of it this weekend.  I even interviewed one of Frigidaire's Refrigerator Engineers for a job at my workplace and he said even he would not buy one of their refirigerators. The range is a terrible design for when you open the oven door a blast of hot oven air hits you smack in the face even as you stand over it.  The smoothtop surface has two small burners in the rear and two large ones up front.  This is not efficient as you always have to reach over large pots to get to the small ones.  When I asked how come they didn't stagger that burners i.e. 1 small front 1 small back, 1 large front, 1 large back, Electrolux said if they did that the back burners would get too hot.  Well GE and Whirlpool don't seem to have that problem so what the heck is wrong with the Engineering at Electrolux.  Now the dishwasher.  Not only does it not do a very good job at cleaning (lotsa residue left) even when using JetDry and Cascade but is doesn't dry the dishes at all as lots of water gets left on things especially glass wear that is on the top rack.  The dishwasher pushbuttons on the front panel are now going bad as we have to fool around a lot with the touchpads to get the thing to start.  Ps.  One year OEM warranty just doesn't cut it as things are falling apart just after the year.  Isn't that always the way?