Shop For Transfer Case Motors

One of our customer's kindly took notes and created a great set of do-it-yourslef instructions for a transfer case encoder motor on a Ford Truck. These were specifically for a 1991 Ford Bronco full size, however they will also work on the following vehicles:

1991-1997 Ford Bronco

1991-1997 Fordf F150

very easy instalation... 3/8 drive socket wrench and 10mm socket needed(drop light may be needed as well as a rubber mallet). there are 4 bolts holding this unit on. one bold holds the back brace on and 3 hold the housing on. there is one plug.

step 1 disconnect plug and swing it out of your way. to disconnect connector from unit depress tab on back and slide downward.

step 2 remove one 10mm bolt from back brace.

step 3 remove 3 bolts from motor housing to transfer case.

step 4 unit can be pretty hard to get off( depending on how long it has been on) so you may need to tap it with a rubber mallet.

Installation

step 1 match the unit female to the transfer case male and slide on.

step 2 line up your bolt holes and start bolts.(you may want to put some thread lock on them to ensure the do not back out)

step 3 tighten all 4 bolts to about 40-50 inch pounds.

step 4 connect the connector back and slide onto the new unit.

now you should be ready to try it out. double check your work and follow your instructions for 4x4 engagement.

on my bronco there was 3 extra wires that were not on the new unit. they went from the wire harness to the back of the transmission. they are no longer needed with the new unit. so cut and tape them off. and have fun. ****This is not the case for all units. Some units require a sensor that also plugs into the extra 3 pins on the new unit.

PEASE RATE OUR GUIDE!!!!   DID THIS HELP YOU IN ANYWAY!!!   VOTES COUNT

Shop For Transfer Case Motors

View Our 100% Positive Feedback

Questions!!! Call us toll free at 1-866-770-2771 or email us!!!

PLEASE RATE THIS GUIDE BELOW!!!!!