A Short History of Jewelry Jigs

A little history:

In 1914 the US Patent and Trademark Organization issued a patent for a metal bending jig with moveable pegs to be used in bending rebar in the construction industry. In the middle 1930's some textbooks for making jewelry with wire showed how to make a fixed peg jig by simply hammering nails into a board. Prior to 1990, artists making jewelry were forced to make their own jig to be used in making their jewelry. In 1995, a patent was issued to Gary Helwig for a wire bending jig that contained a fixed pattern to be used for making jewelry wire components. As that time the Wig Jig compnay was founded to make and sell those fixed peg jigs.

The use of a fixed peg pattern was recognized as having limitations and during the late 1990's a vendor developed a metal jig with removable pegs. At almost the same time, the WigJig company developed a transparent jewelry making jig with removable pegs. In July of 2001 a patent was issued for this "Transparent jewelry wire bender" (US Patent 6,253,798). At this point, the jewelry making community had a choice of a metal jig or the transparent WigJig Olympus; both available options had a square peg pattern with approximately 1/4" spacing between the peg holes.

Modern products:

After 2001, more jewelry making jig options became available.  Several vendors developed metal and plastic jigs with the same basic peg pattern as the WigJig.

In 2003, the WigJig company developed a new jig, the WigJig Delphi , with both smaller pegs (1/16") and a peg spacing of .2" between the peg holes. This jig, because of its smaller pegs and closer hole spacing, is more appropriate for making delicate wire components, including many components for earrings. Later in 2003, the WigJig company introduced the first two commercially available jewelry making jigs with a round peg pattern, called the WigJig Cyclops and the WigJig Electra. The Cyclops has the smaller 1/16" metal pegs of the Delphi and the Electra has the larger 3/32" metal pegs of the Olympus. Finally, in 2004, the Centaur was introduced, which has both a square peg pattern and a round peg pattern in a single jig. The Centaur uses the smaller 1/16" metal pegs.

There are two forms of accessories that are used with jewelry making jigs. The first accessory is rounded pegs in larger sizes.  These pegs are shaped like mushrooms, with the stem of the mushroom fitting into a hole in the jig. The top of the mushroom forms a larger diameter surface for shaping wire around the circumference or a portion of the circumference of the peg. These larger diameter pegs generally come in sizes from 3/16" to as large as 2". Because the pegs must fit into one of the holes in the jig, in general the different vendors pegs are not interchangeable.

The second optional accessory that can be purchased for a jewelry making jig is an accessory to make spirals.  The WigJig Spiral Maker is also patented..

There are many techniques for making jewelry using a jewelry making jig. Most of these techniques can be called "wire wrapping".  This name for making jewelry by hand uses wire components are connected to one another using the same techniques developed during Roman Times. Wire is wrapped around itself to permanently fix a loop in wire and to connect wire components. Techniques for wire wrapping that are commonly used today can be seen in Roman jewelry and in Egyptian jewelry dated to 6 and 7 AD. While the wire used at this time was not modern wire, the techniques to use that wire are still valid today.  At present, we have improved on these ancient techniques through the use of modern materials and jewelry making jigs with removable pegs.

Be sure to see all my Wig Jigs, accessorie and other beading and jewelry tools and supplies here.